Serving Maple Ridge & the Lower Mainland since 200924/7 urgent HVAC service: 604-479-5919

Burnaby HVAC service

Gas Fireplace Installation, Repair & Cleaning in Burnaby

Planning a fireplace installation, replacing an existing unit or arranging service? High Demand Heating helps Burnaby homeowners define the equipment and work involved, with appointments scheduled from our Maple Ridge base.

Residential gas fireplace operating inside a finished living room mantel
HDH project photo · location not specified

Gas odour or a carbon-monoxide alarm? Get outside first.

Gas odour or a suspected gas leak: Stop what you are doing and leave the area. Do not use phones, operate electrical switches or appliance controls, smoke, light matches or create other ignition sources in the area. Once outside, call FortisBC at 1-800-663-9911 (24 hours) or 911. Follow emergency responders’ instructions.

CO alarm sounding or suspected carbon-monoxide exposure: Get everyone, including pets, outside immediately. Do not stop to find the source. Call 911 from outside. Stay outside until emergency responders confirm it is safe to return.

Smoke, scorching or fire: Get outside and call 911 from a safe location. Do not wait for an HVAC callback.

The checks and service form below are for situations without emergency warning signs. Do not troubleshoot or wait for High Demand Heating to respond to a suspected gas leak or CO alarm.

Official guidance: FortisBC gas-leak safety and Technical Safety BC carbon-monoxide safety.

What do you need help with?

  • The pilot will not stay lit
  • Delayed or weak ignition
  • Soot, odour or unusual flame
  • Controls not responding
RepairMaintainReplace

Tell us what changed. We’ll confirm the next step.

Service details & booking adviceRepairs, visit scope and what to prepare

Local service, properly confirmed

Start your fireplace project with the installation conditions

A photograph of a fireplace you like is a starting point, but the proposed location determines what can be installed. Tell us whether there is an existing fireplace opening, an old gas appliance to remove or a new room layout being planned. Include room photos and any safely accessible equipment label.

For a Burnaby house, townhouse or strata unit, describe access to the room and any exterior area the project may involve. Building contacts, loading arrangements and ownership of the existing equipment should be clear before an assessment. The office confirms service availability and the next step for your property.

Common reasons to call

  • The pilot will not stay lit
  • Delayed or weak ignition
  • Soot, odour or unusual flame
  • Controls not responding

Decisions to make before selecting a fireplace

  • New installation, existing insert replacement or repair
  • Available opening, vent route and service access
  • Gas and electrical supply, controls and room-heating needs
  • Mantel, surround, finishing work and property approvals

New gas fireplace or replacement insert?

An insert for an existing fireplace opening and a built-in fireplace for a new location need different assessments. The opening, surrounding construction and available venting must suit the proposed appliance. A replacement with a similar visible size may still have different installation requirements.

Discuss how the room will be used, the heat you want from the fireplace and the controls you prefer. A fireplace intended for room heating should be considered alongside the home's existing heating system. Do not select it on appearance or the old model's dimensions alone.

Venting, utilities and the finished surround

Before finalizing a model, an assessment needs to consider a suitable vent route, appliance clearances, gas supply, electrical requirements and access for future service. An existing connection or chimney does not establish compatibility with every new unit.

Bring the mantel, wall finish and surrounding renovation into the discussion early. Ask which removal, connection, installation and finishing tasks are included and which require separate arrangements. A complete scope makes it easier to compare estimates than an appliance-only price.

Fireplace installation in a Burnaby strata property

Establish who owns the fireplace and who can authorize changes before equipment is ordered. Ask the strata contact about proposed work affecting the exterior, shared components or common property. Requirements depend on the building and the project; approval for one unit does not establish permission for another.

Share any building access, elevator booking, loading or contractor-coordination requirements with the office. An assessment can then consider the installation conditions alongside the appliance choice. Confirm these arrangements before a work date is agreed.

Repair an existing fireplace before deciding to replace it

If your current fireplace will not light, loses its pilot or stops during operation, describe that fault when requesting service. Include the model and whether the pilot, main burner, wall switch or remote responds. A diagnosed problem gives a better basis for comparing repair with replacement than age alone.

The condition of the appliance and suitable parts availability affect the options. Ask about the diagnostic appointment terms and how additional repair work will be approved. Avoid bypassing controls or repeatedly trying to run an appliance with abnormal ignition; internal gas components need qualified service.

Cleaning and ongoing fireplace maintenance

For a fireplace that operates normally, maintenance can address accessible cleaning and model-appropriate checks of the burner, ignition system, seals, venting and controls. Mention any recent change in operation so the office can distinguish routine care from a fault that also needs diagnosis.

Use the appliance manual to guide routine care and ask for the service findings after professional maintenance. Fireplace glass can remain hot after the flame is off. Keep people and combustible items away from the hot surface and allow it to cool before touching it.

High Demand Heating gas fireplace work

Gas fireplace equipment and customer experiences

Company-wide project photography and paraphrased customer feedback. These examples are not identified as Burnaby jobs.

Paraphrased customer review

Alfonso Rivera

Alfonso highlighted furnace and gas-fireplace work, along with prompt arrival, clear knowledge, careful cleanup and a thorough approach.

  • Furnace service
  • Gas-fireplace service

Paraphrased customer review

Ray Jenkins

Ray described returning for annual maintenance of a furnace, fireplace and tankless water heater.

  • Annual maintenance
  • Multiple gas appliances

Local service questions

Fireplaces questions in Burnaby

These answers help prepare the request. Equipment condition and approved scope still determine the final recommendation.

Do you install gas fireplaces in Burnaby?

High Demand Heating schedules Burnaby fireplace installation and replacement assessments from its Maple Ridge base. Share your existing equipment or planned location so the office can confirm the assessment scope and availability.

Can a new gas fireplace use my existing venting?

That needs assessment against the proposed appliance and installation conditions. An existing vent or chimney does not confirm compatibility with a new fireplace. Opening dimensions, clearances, utilities and access also matter.

What should a fireplace installation estimate include?

Ask for the proposed model, removal scope, venting and utility work, controls, installation tasks and any finishing or access exclusions. Identify property approvals and who is responsible for each part of the project before agreeing to the work.

Can you replace a fireplace in a Burnaby condo?

Discuss appliance ownership, building access and the proposed changes with the office and the responsible strata contact. Common-property, exterior or shared-component work may need approvals confirmed before equipment and installation are agreed.

Should an old fireplace always be replaced?

No. Diagnosis, appliance condition, repair history and suitable parts availability should inform the decision. Compare a practical repair with the full replacement scope, rather than assume age alone determines the answer.

Does a fireplace maintenance visit include fixing an ignition fault?

Report the fault when booking so troubleshooting can be discussed separately from routine cleaning and maintenance. The office confirms the intended work and appointment terms before the visit.

24/7 urgent HVAC service

Need gas fireplace help in Burnaby?

For a service issue without emergency warning signs, call or request a callback so our office can confirm the next step.

Request service604-479-5919