Serving Maple Ridge & the Lower Mainland since 200924/7 urgent HVAC service: 604-479-5919

Mission HVAC service

Boiler Repair, Maintenance & Installation in Mission

Boiler service for dependable hydronic heating, including diagnosis, maintenance, repair and replacement planning.

Wall-mounted Navien hydronic heating system with storage tank and copper piping
HDH project photo · location not specified

Gas odour or a carbon-monoxide alarm? Get outside first.

Gas odour or a suspected gas leak: Stop what you are doing and leave the area. Do not use phones, operate electrical switches or appliance controls, smoke, light matches or create other ignition sources in the area. Once outside, call FortisBC at 1-800-663-9911 (24 hours) or 911. Follow emergency responders’ instructions.

CO alarm sounding or suspected carbon-monoxide exposure: Get everyone, including pets, outside immediately. Do not stop to find the source. Call 911 from outside. Stay outside until emergency responders confirm it is safe to return.

Smoke, scorching or fire: Get outside and call 911 from a safe location. Do not wait for an HVAC callback.

The checks and service form below are for situations without emergency warning signs. Do not troubleshoot or wait for High Demand Heating to respond to a suspected gas leak or CO alarm.

Official guidance: FortisBC gas-leak safety and Technical Safety BC carbon-monoxide safety.

What do you need help with?

  • No heat or uneven heating
  • Leaks or pressure issues
  • Unusual boiler noise
  • An old, inefficient system
RepairMaintainReplace

Tell us what changed. We’ll confirm the next step.

Service details & booking adviceRepairs, visit scope and what to prepare

Local service, properly confirmed

Boilers service for Mission properties

Mission service is planned as a Fraser Valley route from Maple Ridge. Detached homes, townhomes and light-commercial properties may have varied equipment access, so the office confirms scope and travel before booking.

For hot-water and boiler equipment, include fuel, visible leaks, error codes, repair history and whether the request is urgent or replacement planning.

Boiler service considers the appliance and the hydronic system it serves. Pressure, temperature, pumps, zones, controls, venting and visible leakage can all affect whether heat reaches the building.

Common reasons to call

  • No heat or uneven heating
  • Leaks or pressure issues
  • Unusual boiler noise
  • An old, inefficient system

A complete look at the boiler and heating system

Boiler problems can come from the appliance, controls or the hydronic distribution system. Diagnosis may include operating pressure and temperature, visible leaks, ignition, pumps, zones, controls, venting and the way heat reaches the building.

Boiler controls, ignition and operating cycle

The exact check depends on the equipment, access and approved service scope.

Pressure, temperature and visible leak concerns

The exact check depends on the equipment, access and approved service scope.

Circulation, pumps and accessible zone controls

The exact check depends on the equipment, access and approved service scope.

Venting, condensate and safety components as applicable

The exact check depends on the equipment, access and approved service scope.

Boiler repair or replacement planning

A repair can be the right answer when the equipment is serviceable and the failure is isolated. Replacement planning should consider boiler condition, repair history, building heat loss, radiation or in-floor zones, domestic hot-water needs and venting—not just the rating on the old nameplate.

What we can help with

Boiler diagnostics

Safety and performance maintenance

Repair and component replacement

Boiler installation

Prepare for a boiler appointment in Mission

Send the equipment label, clear installation photos and the exact symptom. Complete information helps determine whether the request fits a scheduled route and what the technician should prepare before leaving.

Note whether every zone or only one area is cold, and photograph any code or pressure display. Do not add water, bleed components or adjust gas controls unless you are following qualified, system-specific instructions.

Local service questions

Boilers questions in Mission

These answers help prepare the request. Equipment condition and approved scope still determine the final recommendation.

Do you provide boiler service in Mission?

Yes. High Demand Heating schedules boiler work in Mission when the requested scope, equipment, access, urgency and route availability are confirmed by the office.

What should I include with a boiler request?

For a service issue without emergency warning signs, include the brand and model if available, the exact symptom, when it began, any error code or leak, the property type and access details. Call the office for urgent HVAC service. For a suspected gas leak, leave and call FortisBC at 1-800-663-9911 or 911 from outside. For a CO alarm, get everyone outside and call 911 from outside. Stay outside until emergency responders confirm it is safe to return. Do not wait for a service callback.

How often should a boiler be serviced?

Annual service is recommended for most boilers to check safe operation, controls and system performance.

24/7 urgent HVAC service

Need boiler help in Mission?

For a service issue without emergency warning signs, call or request a callback so our office can confirm the next step.

Request service604-479-5919